|
aHR0cDovL2ZyZWVzaGlwLmNvLmty
- Áõ¸í¼: NONE
- ±Ù¿ø: CN (Á¤Ç°)
We offer discount for large quantity. Welcome to contact with us!
Stepper Motor Drive Simple Controller PWM Generation Controller Pulse Generation
1. When the controller generates a pulse frequency signal, it can be supplied to the stepper driver as a signal. If you want to control the stepper motor, it must also be equipped with a driver. This simple controller + stepper driver + stepper motor + DC power supply can form a simple control platform. 2. The controller can generate pulse frequency signal and PWM pulse width signal. There is a jumper on the board, which can be set and selected. By default, it is set to generate pulse frequency signals. REQ is to generate a pulse frequency signal. PWM is to generate PWM signal 3. When the controller generates a pulse frequency signal, there are three frequency signals of high, medium and low, which can be selected by the jumper. The frequency parameters are about: High: 5.8KHZ-127KHZ; Middle: 590HZ-15.8KHZ; Low: 82HZ-2.3KHZ, Frequency measurement: PUL and common cathode (GND) ports can be measured. 4. There are 2 groups of power input for power supply, and 2 groups only need to be connected to one group of power supplies. It is recommended to use a power supply above 15V. Connect to the power supply of the 2-position terminal, and do not reverse the positive and negative.
One group is the power supply connected to DC 15-160VDC, and the recommended working voltage is 15-80VDC. The other group is 5-12VDC. When used with the driver, it is recommended to use a minimum of 12V, do not use a 5V power supply for power supply, it is not too much at 5V, the power supply is connected to ""5-12V input"", and the negative power supply is connected to ""common cathode"". 2. Wiring instructions 1. For the wiring of each wiring port, there are silkscreen instructions next to the terminals. Common cathode or common anode can be connected to the stepper motor driver. PUL: Pulse port DIR: Direction port ENA: enable port Commoncathode: common ground (GND) Common anode terminal: common terminal (+5V) 5-12V power supply is positive: the positive terminal of 12V power supply is generally empty, it is recommended to use a power supply above 15V. Material: PCB colour: As shown
Package Contents: 1 x Stepper Motor Controller
Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
About Us
Please believe our customer service staff loyalty and handle ability. Do not easily give a negative evaluation and bad feedback stars . Because the evaluation is unable to change ,feedback can¡¯t change, We need to communicate and understand each other.
About Payment
If you meet any problem when making the payment, please contact AliExpress Customer Service Center to ask for help:
About Feedback:
1. Please check the package and item when you get carefully to make sure there is no problem.
2.
If you have any problem or are not entirely satisfied with your
package,please don¡¯t be hesitate to contact us first before leaving
negative feedback. We will resolve the problem to satisfy you.
3. If there is no problem, please leave us 5 star positive feedback.
Your affirmation is our greatest motivation ! ! !
|
|
|
|
|