aHR0cDovL2ZyZWVzaGlwLmNvLmty
- ¸ÂÃã °¡´É À¯¹«: ±×·¸½À´Ï´Ù
- »ç¿ë¹ý: General-purpose
- ¸ðµ¨ ¹øÈ£: GYL1184
- ºê·£µå À̸§: EChipTEC
- ±Ù¿ø: CN (Á¤Ç°)
- Input voltage: 7V-36V
- Output voltage: 1.5-35V
- Output power: 150W
Voltage calibration:
In the case of power failure, press and hold the "Settings" button, power on, enter the voltage calibration mode, the LCD screen starts to flash, release the set button, press the "Set" button to increase, "OK" to decrease, and the calibration is correct The input terminal voltage, such as: the input voltage is 12.65V, then the current voltage will be adjusted to 12.65V, and it will be automatically saved after 2 seconds. The calibration is completed when the power is turned off and exited!
parameter:
Input voltage: 7V-36V
Output voltage: 1.5-35V continuously adjustable (can only be used as a step-down module, the input must be greater than the output 1.5V)
Output current: adjustable, maximum 10A (recommended to use within 8A, 5A or 70W can be used at room temperature to dissipate naturally, please strengthen heat dissipation when exceeded! It is recommended to add a small fan! Matching fans are available in this shop! Constant current requires an output voltage of 2V or more It can be adjusted, and the current adjustment is only effective in the constant current state.)
Output power: 150W (recommended to use within 100W, please reduce the power when using large pressure difference)
Working temperature: -20~+75 degrees (pay attention to the temperature of the power tube when using, please strengthen heat dissipation if it exceeds)
Working frequency: 300KHz
Conversion efficiency: 95% higher
Short circuit protection: Yes, the constant current value currently set
Input reverse connection protection: Yes (new features in the upgraded version!)
Output reverse flow: None, please add a diode for charging! Available in this shop!
Installation method: Acrylic plates on the upper and lower sides, 8 copper pillars, 8 3mm screws, and it is easier to install the keys in reverse!
Wiring mode: terminal or welding terminal, IN is input, OUT is output
Size: length 80mm width 53mm height 35mm
Application range:
Note that the constant current adjustable current must be in constant current mode only when the actual load output current is greater than the set current, otherwise it will work in a constant voltage state, not the current is adjusted to 2A, that is, it will become 2A if any equipment is connected. Know. The constant current of output voltage above 2V will take effect!
1. Use as an ordinary step-down module with overcurrent protection capability
More details can feel free to contact us, Thanks ^^