Adjustable suction lamp controller£¬MOSHigh power output£¬PWMPulse width modulation voltage¡£
The circuit is shared by the negative pole£¬Positive control£¨Adapt to negative grounding of vehicle line£©¡£
be careful£ºDon`t put it under the hood of a car£¨Stay away from the engine£¬The temperature there is too high£©¡£
PWMmodulation mode £¬With additional circuit£¨Such as constant current drive, etc£©High powerLEDNot applicable£¡
Parameter description£º
1¡£Applicable voltage£ºDC5-24V£¨The peak value of the output voltage is approximately equal to the input voltage£©£»
2¡£Typical usage in12VUnder power supply£¬meet12VYesLEDLamp group£¨If directly connected12VLight band, etc£©£»
3¡£Adjustable respiratory cycle£ºabout0.5second-20second£»
Because it is a variable resistance potentiometer£¬The limit value will deviate a little£¬However, the limit value will exceed the adjustable range value£¡
4¡£Product shell size£º49mm*28*20mm£¨Not including protective wire sleeves on both sides£©£»
5¡£Lead extension length approx12CMabout£»
6¡£The voltage modulation mode of this product isPWMPulse width modulation voltage regulation£¬If it is with constant current driveLEDThe lamp group may destroy the outputPWMThe waveform does not form a gradient£»
7¡£MOSTube output£¬With load capacity3ANo pressure inside(Real through current)¡£
8¡£The input and output directions are as shown on the label on the housing¡££¨inSide is input£¬outSide is output£¬Red wire connection¡°+¡±£¬Black wire connection¡°-"£©